4 x Brake Caliper Covers for Honda and Acura Civic Jazz Type R CR V FR V Type R

Description: BRAKE CALIPER COVERS 4PCS ( 2 FRONT and 2 REAR ) small size: 230mm x 65mm x 40mm - rearbig size: 280mm x 65mm x 60mm - front Before you buy, please find out the size ofyour car caliper and compare the size of the caliper covers. Very Easy Install with Silicon Glue 100% Brand New Made of high quality plastic! Very Easy Install with Silicon Glue. FEEDBACK:Please leave us 5 perfect stars if You are satisfied with our service. If You are dissatisfied, contact us first and we will resolve problems as much as we can do for You. THANK YOU !!! **Step-by-Step Guide:** 1. **Safety First**: - Park the vehicle on a level surface and engage the parking brake. - Ensure the engine is off and the wheels are cool to the touch. 2. **Prepare the Vehicle**: - Remove the wheel where the caliper cover will be installed. This typically involves loosening the lug nuts, jacking up the car, and then removing the wheel. Refer to your vehicle’s manual for specific instructions. 3. **Clean the Calipers**: - Thoroughly clean the brake calipers with soap and water to remove any dirt and debris. - Once dry, wipe down the calipers with alcohol to ensure all grease and residues are removed. This step is crucial for proper adhesion of the silicone. 4. **Test Fit the Covers**: - Place the caliper covers over the brake calipers to ensure they fit correctly. - Make any necessary adjustments as per the manufacturer’s instructions. 5. **Apply the Silicone Adhesive**: - Apply a generous bead of high-temperature silicone adhesive to the inside of the caliper covers. Focus on the areas where the cover will contact the caliper. - Be sure to follow the silicone adhesive manufacturer’s instructions for application and curing times. 6. **Attach the Caliper Covers**: - Carefully place the caliper covers over the brake calipers. - Press firmly to ensure good contact between the adhesive and the caliper. - If needed, use painter’s tape or clamps to hold the covers in place while the silicone cures. 7. **Allow Time to Cure**: - Follow the adhesive manufacturer’s guidelines for curing time. This typically ranges from a few hours to 24 hours. - Do not drive the vehicle until the silicone has fully cured to ensure the covers are securely attached. 8. **Reinstall the Wheels**: - Once the silicone has cured, remove any painter’s tape or clamps. - Reinstall the wheels and securely tighten the lug nuts in a star pattern. - Lower the vehicle and double-check the lug nuts for tightness. 9. **Final Inspection**: - Inspect the caliper covers to ensure they are properly installed and secure. - Test the brakes at low speed to ensure they are functioning correctly.

Price: 59.9 USD

Location: Sofia

End Time: 2024-11-17T16:17:56.000Z

Shipping Cost: 0 USD